Swim Spa Installation

Yes, the foam pads are supplied and are located between the two layers of shrink wrap when the pool ships. You can take off one layer of shrink wrap to remove the pads only, set the pool in place and leave the pool in the second layer of shrink wrap to keep the pool clean during construction. The foam pads should be placed on the slab as labelled. This is very important. On one-piece pools, the three reinforcement ribs should not be sitting on the foam pads. On four-piece pools, the flanges should not be sitting on the foam pads, nor should they touch the concrete slab.

It is important for the pool to sit on a flat level concrete pad for the water flow to work optimally.

Yes, it is the customer/installer’s responsibility to remove the SwimEx from the truck. This can be accomplished via a crane, forklift or lull truck, depending on your site. We have installers who can handle this for you.

All SwimEx pools come standard with a heater, filtration pump and filter.

No, this is supplied by the installer/electrician/plumber. SwimEx does provide shut-off valves for all inlet and outlet fittings.

70 Amps for paddlewheel (54 FLA)
30 Amps for heater (FLA 23)
15 Amps for pump (FLA 7.1)

At the front of the SwimEx, there is a SwimEx decal with the water fill line marked across the bottom. This is the ideal water depth. Most SwimEx units will hold 2600 or 3200 gallons.

No. Even if there is a power outage, the variable speed controller does not need adjustment.

It is possible to add a hard top cover afterwards. Call SwimEx for details.